Calling upon a command with variables without affecting them

[arctic992]

So I’m not sure if I’m just missing something obvious or if it actually is a bit confusing. Im moderately new to this, so it could be either. I’m trying to set up a death count, and a death recall command. The death count is all set, using the $(count) variable, but now I’m trying to make another command to call up that number from $(count) without increasing the value. Any help would be greatly appreciated.

[Slikrick]

This is actually a common question due to the slightly complicated nature of doing this. There are a couple ways to do so, you can see this post on what commands you need and what can be changed

If you have any questions on what is going on feel free to ask.

Some other threads specifically about death commands:
Some sort of counter to track deaths that viewers can view but not change and maybe a way to reset
Create an editable counter?
Is there a $(count) reset

[arctic992]

Thanks a lot man! It works like a charm now, although I did have a few mistakes putting it in but it all worked out!